The possibility of a sewer drain that it could become clog is when a non-recyclable material makes its way to the sewer drain. Elimination of the blockage must be performed so that the sewer drain will not be clogged. If the sewer line is not broken, an ordinary person can eliminate the blockage to prevent the sewer drain from clogging. Declogging of the sewer drain must be done over and over again until the blockage is found. The main sewer drain must be located at the outside part of the house. A wide pvc pipe termed as a soil stack is a three to four inches elevated from the ground. Attached to a straight pipe is a curve pipe that can be found at the end. A curve can carry a blockage sometimes.
Put aside the cap of the main drain after its removal. The cutting blade will be placed at the end of the auger line. Positioned at the end of the auger line is a groove where the head of the cutter blade fits into. Located on the auger line are two holes while located on the auger bit is only one hole. Auger line has two holes and the auger bit has one hole. Before tightening the screw, it must be inserted through the holes. The tip of the auger must be placed into the main drain. Before turning on the power, the auger directional button must be fed to the line out.
You can feel that you hit something by holding on to the auger line while feeding it into the main drain. The clog will be removed by the continuous feeding of the line. The auger line must be stopped when it it hits something. If this happens, the line reached another piper. A pipe is reached when the auger line hits something.
If the clog is already located, remove the toilet nearest to where it appears. Connected by the sewer line are the toilet and the soil stack. At the lower portion of the soil stack, the clean-out cap must be accessed through digging at the bottom of the house if the house has no crawl space. By passing through the toilet drain, the auger line can be run there to remove the toilet. Put off the water supply and drain the water from the toilet prior to removing the toilet.
You can spot under the kitchen sink for a clean-out, a cap on a pipe. The source of the water must be shut off prior to removal of the clean-out cap. Until the auger breaks through the clog, the auger must be fed slowly before inserting the auger into the clean-out. Through flushing the water into each line through the auger, the sewer line can be checked if its already clean or not.
Why People Think Sewers Are A Good Idea
Why not learn more about Cleaning?